Why the air can enter in Canon infusion hose?
The air in the hose drip Canon caused by the existence of a gap between the catrid hole and rubber hose place drip infusion into catridge. Or more simply put, connection hose and catrid "loose". This vulnerability occurs because catrid does not match the hole rubber, because at the time repeatedly catrid by simply soldering/eye drill that does not correspond to the diameter of the rubber and knee infusion. As a result, the air will gradually be able to fit in a hose drip.
Equipment To Cope With The Air In The Hose Drip Canon:
- Glue
- Canon Catrid Vacuum Toolkit
How To Cope With The Air In The Hose Drip Canon:
Prepare the Glue (do not use glue ALTECO, can damage plastic)
Take the hose off and do not Catrid infusnya.
Glue the parts of the suburbs of catrid hole place hose in, try not to get in the air.
Allow the Glue to dry out first.
Open the lid of a respiratory tube Infusion
Prepare a Toolkit of vacuum Catrid Canon, then plug the Catrid into the Toolkit.
Plug the SPUIT/Injections without a needle into the rubber hole on the bottom of the Vacuum Catrid Toolkit.
Then tintanya to suck air in the hose is missing.
The printer is already Ready.
Advice to avoid problems occur Air hoses included in the infusion:
Use an appropriate infusion of drill diameter rubber hose L place Drip infusion. This drill has a size of diameter of 2.2 mm
No comments:
Post a Comment