How to Service a Seagate hard drive eror

In fact I often find this case, namely the Seagate konslet hard disk. Konsletnya hard drive is causing the power supply also died or to the protectionism and any computer can not be turned on. You might have ever or are currently experiencing this, namely your seagate hard drive konslet, when a lot of data stored in the hard disk. How do I service the seagate konslet hard disk?

Here I will try sharing about how to service a hard drive seagate konslet.

Seagate hard drive causes a Konslet:
The presence of excess voltage of the power supply to the hard drive (Over Voltage)

Preparation Tool:

• Screwdriver Star: to open the screw board hard drive.
• The Multitester to check components: diodes damaged.
• Solder and lead: used to replace components damaged wrote.
• Spare part diode 1A-2A: buy at electronics.

How to Service a Seagate hard drive error:

• For the layout of the components are konslet hard drive is on the inside, you need to open a board inside the hard drive

• For the konselet hard drive components already seen directly, you do not need to open up the board.
• Konselet on harddisk Seagate this often happens at the safety voltage of 12 volt DIODES. Voltage 12 voltnya i.e. suply power cable which is yellow. While the voltage is 5 volts red wires. Sometimes a safety DIODE voltage 5 volts have also been konslet but rarely.

• Check the DIODE voltage safety voltnya 12. also check the DIODE 5 safety voltnya. look at the picture.
• Immediately replace the harddrive konselet diodes. with 1-2 Ampere diode, electronic shops to buy much. Note the position of the anode and cathode is. In fact by just removing the damaged diode without replacing them, your hard drive will be back to normal. In this way, however I do not recommend, because without the diode means without protection if there is over voltage/excess voltage.